Rabbit-skin glue

(Redirected from Rabbit skin glue)

Rabbit-skin glue is a sizing that also acts as an adhesive. It is a type of animal glue that is essentially refined rabbit collagen. The glue has been used for centuries for stretching and priming canvases for oil painting. It has also been an ingredient in traditional gesso.

Rabbit-skin glue, in pellet form (left) and partially dissolved in water (right)

History

edit

In traditional oil painting as practiced by the Renaissance painter, skin glue was used to seal the canvas. This is necessary because the linseed oil that forms the base of most oil paint contains linolenic acid that will destroy the canvas fibers over time. Renaissance artists also knew that pure size (hide glue) became brittle once dry, and would mix it with oil and chalk to make a "half-ground" for canvases. Pure hide glue was usually applied only to rigid supports like panels. Though this does help to seal the canvas or panel, artists still applied a layer of "oil ground", which was often lead based paint, in order to provide a binding layer for the final oil paint to adhere to.

Production

edit

Rabbit skin glue is an animal glue created by prolonged boiling of animal connective tissue. Rabbit skin glue can be bought in powder form, little pellets or in larger chunks. Preparation involves using the correct proportion of water to glue to achieve the correct consistency and strength. It should be heated to just short of the boiling point. Too much heat results in a product with reduced adhesive qualities. Manufacturers of rabbit, and cow & horse hide glue recommend dissolving at 60–63 °C (140–145 °F).

Uses

edit

Adhesive

edit

As an adhesive, rabbit-skin glue is used in the production of the bellows of concertinas, and in other smaller, light instruments—prominently in violins. Its supreme advantages are very fast bonding and easy debonding with hot water, if an instrument must be disassembled for internal repairs. It also has very low creep, which is the tendency of some glues to plastically yield under even low but consistent stresses over time. For example, guitar bridges are subject to high lateral stresses that, with the wrong glue, can lead it to creep forward.

The proteins of the glue soak into the wood and interlace with its pores. Setting of the glue occurs with cooling and drying, so the working time is very short, on the order of minutes, to stick the parts together and get full strength, unlike PVA glue which might provide 20–30 minutes. Furthermore, since the glue only works by microscopically stitching the wood fibers together, any gaps in the joint are not going to be successfully filled, and so the mating surface must be very smooth.

Sizing

edit

When used in painting as a sizing, it is spread evenly over a canvas that has been placed on the stretcher. When the glue dries, it tightens the canvas. The canvas should be left to dry in normal room temperature for at least 12 hours. Under no circumstances should the canvas be placed to dry under harsh sunlight or other heat, because the glue will start to crack. Air humidity also affects how tight the canvas will dry. This process should be then repeated once more. After this if needed, the canvas can be lightly sanded flat.[1] Then an oil-based primer is applied.

A canvas sized with rabbit-skin glue can be made tighter than with other alternatives—such as an acrylic-based gesso—because of the shrinkage. This type of canvas is also valuable because it can be sanded to a flatter texture, which allows the painter to achieve a finer level of detail than can be achieved with a typical acrylic gesso ground.

This rabbit-skin glue ground is only appropriate for use under oil paint. Acrylic-based media will flake off a canvas prepared with rabbit-skin glue and are therefore not appropriate.[2]

Rabbit skin glue is considered to be a major cause of cracking in oil paintings by most modern conservators. Because the glue is hygroscopic, it continually absorbs moisture from the atmosphere, causing the glue to swell and shrink as ambient humidity levels change. Over many humidity cycles, this repeated flexing causes the brittle oil paint to crack. Modern substitutes for rabbit skin glue are available, such as Gamblin's PVA size [3] and Golden Acrylics’ GAC100. These substitutes do not have the hygroscopic properties of rabbit skin glue, while still being very slightly hygroscopic, and should not cause the damage to oil paints that rabbit skin glue does. However, these modern replacements do not stiffen and tighten the canvas as well as rabbit skin glue does, so some artists still prefer to use rabbit skin glue.

See also

edit

References

edit
  • Mayer, Ralph; Sheehan, Steven (1991). The Artist's Handbook Of Materials And Techniques. Viking. ISBN 978-0-670-83701-4.
  1. ^ Oja, Onni (1962). Taidemaalauksen käsikirja [The Handbook of Painting] (in Finnish). WSOY. pp. 22–26.
  2. ^ Gottsegen, Mark D. (1993). The Painter's Handbook. New York: Watson-Guptill Publications.
  3. ^ "Gamblin Artists Colors". Archived from the original on 2007-10-25.