Jump to content

Bedford QL

From Wikipedia, the free encyclopedia
(Redirected from Bedford QL1)

Bedford QL
A QLR on show
Place of originUnited Kingdom
Service history
Used byBritish Armed Forces
WarsSecond World War
Production history
ManufacturerBedford (General Motors)
Produced1941-1945
No. built52,247
VariantsQL1, QLB, QLC, QLD, QLR, QLT & QLW
Specifications
Mass7,225 lb (3,277 kg) (empty)
15,400 lb (6,985 kg) (loaded)
Length5.99 m (19 ft 8 in)
Width2.26 m (7 ft 5 in)
Height10 feet / 2.54m
Crew1 + 11 passengers

Armournone
EngineBedford, 6-cyl 3,519 cc (214.7 cu in) petrol
72 hp (54 kW)
Payload capacitytons
SuspensionWheel, 4x4
Operational
range
156 mi (250 km)

The Bedford QL was a series of trucks, manufactured by Bedford for use by the British Armed Forces in the Second World War.

History

[edit]

At the outbreak of WW II, Bedford was contracted by the British War Office to produce a 3 ton 4×4 general service truck. A pilot model was ready in February 1940 and quantity production started in March 1941.[1] The Bedford QL was in production from 1941 to 1945 and was Bedford's first vehicle series built for the military.[2]

Variants

[edit]
QLD
Preserved RAF QL refuelling tanker at IWM Duxford
Bedford QL Breakdown Truck
QL1
Prototype.[2]
QLB
Bofors gun tractor.[2] Approximately 5,500 QLBs were built.[3]
Several QLBs were fitted with shortened GS bodies and recovery cranes to be used as wreckers by the Danish Army (Used until late 1960s).[4]
QLC
Fire engine.[2]
Signals vehicle.[2]
Petrol tanker.[2]
QLD
General service cargo truck and was the most numerous version in the series.[2]
Machinery.[2]
Kitchen.[2]
Battery storage.[2]
QLR
Signals vehicle.[2] Originally mounted on the QLC chassis/cab, special QLR chassis were soon put into production, which differed from the standard type in having special electrical equipment, radio suppression, fitment of a 660 W auxiliary generator driven by the transfer case power-take-off and, like the QLT, two 16 gallon petrol tanks instead of one behind the cab. The interior furniture, partitioning and radio equipment varied with the different functions. On vehicles installed for the wireless role, a tent could be erected at the rear. Between cab and man body were lockers for aerial masts and other equipment. Beneath the body were further lockers and racks for cable drums, batteries, tyre chains, 20 gallon drinking water tank, rectifier box, tools, fuel tank for the auxiliary engine, jerrycans and other items. The basic body shells were produced by Duple, Lagonda, Mulliner, Tickford and others. A revised body was introduced during 1944 for the Command High and Low Power and Wireless High Power roles. This body had an improved L-shaped tent which could be erected alongside the left-hand side and rear of the body.[5]
QLT
Troop carrier.[2] From August 1941 and until the end of WW II more than 3,300 QLTs were produced.
QLW
Air portable tipper.[2]
Lorry, 3 ton, GS Bedford half-track (Bedford-Bren)
Following the fall of Singapore rubber was scarce and so at the request of the Ministry of Supply a Bedford QL was adapted using a Carden Lloyd suspension [6] taken from a Bren Gun Carrier. While the Bedford-Bren[7] was capable of impressive feats of tractive power (which could have been easily produced in its own right as a prime mover) British authorities, unlike the Americans and Germans, did not favour the half-track. The shortage of rubber was not as severe as anticipated and official interest in the project waned. Not only did this British parallel to the German Maultier not go into production, the single prototype was converted back into an all-wheel vehicle.[8]
Lorry, 3 ton, 4 x 4, Bedford, experimental (Bedford Giraffe)
An attempt to make a motor vehicle capable of deep wading for river crossings and amphibious landing, the Bedford Giraffe was developed as insurance against the shallow wading kits under development not proving effective in deeper water. As a 'plan B' Vauxhall adapted a Bedford GL by mounting its engine, cab and gearbox on an elevated girder frame some seven feet high, with a chain drive transmitting power to the propshaft. The ungainly but effective vehicle demonstrated it was a viable solution should hastily extemporised waterproofing kits fail but they proved effective and so no specialised type was required.[9]

References

[edit]

Citations

[edit]
  1. ^ "Bedford QLD". Danish Army Vehicles.
  2. ^ a b c d e f g h i j k l m Ware 2012, p. 199.
  3. ^ "Bedford QLB". Danish Army Vehicles.
  4. ^ "Bedford QLB".
  5. ^ "Bedford QLR". Danish Army Vehicles.
  6. ^ "Panzerserra Bunker- Military Scale Models in 1/35 scale: Bedford QL halftrack prototype - case report". Panzerserra Bunker- Military Scale Models in 1/35 scale. Retrieved 7 August 2023.
  7. ^ http://3.bp.blogspot.com/-cWZRlB1wFxQ/UOK27zEZ7GI/AAAAAAAAJY0/xdIgGuOhbZ0/s400/real+bedford.jpg [bare URL image file]
  8. ^ Coates, Robert (1994). Bedford to Berlin and Beyond QL: the Forces Favourite 4x4. Motorbooks International. ISBN 9780948358050.
  9. ^ Ellis, Chris; Bishop, Denis (1971). Military Transport of World War II. London: Blandford Press Ltd. pp. 129. ISBN 0-7137-0702-X.

Bibliography

[edit]
[edit]